Search Results for "from"

A Swagelok changeover (SCO) is a special type of primary gas control system, pre-engineered for applications where the continuous supply of gas is critical. Accomplished through staggered set points of two pressure regulators, the SCO will switch from a primary to a secondary source of gas when the ...

• ZH
• ES
• FR
• RU
• DE
• EN

SSI Systems are designed to handle incoming gases usually from a bottle or bottle multi pack source. The gas will flow thru the SSI and connect to one of the other Swagelok systems, typically a Swagelok Gas Panel (SGP), where the pressure can be regulated.

• ZH
• ES
• FR
• RU
• DE
• EN

Leave valve in the open position; Loosen and remove the eight body bolts from the center body; Remove center body from between the flange ends; Remove and discard the flange seals and seat subassemblies from both sides of the center body.

• ZH
• JA
• EN

When installing a BV series bleed valve, position the vent tube so that system fluid is directed away from operating personnel; Always open bleed valves slowly; These valves contain no packing, therefore some fluid weepage will occur when the valves are opened.

• ES
• FR
• RU
• DE
• EN

Open the valve; Remove the body fastener from the “C” location on the swing-away side of the valve; Loosen the remaining body fasteners.

• ZH
• ES
• FR
• JA
• DE
• EN

Remove the two screws from the left side of power supply and discard.

Remove three (3) Capscrews from Cylinder Cap (9/64 in. hex wrench) and remove Cap; Remove Spring(s) - “1C” model only; Unscrew Bonnet Nut (1 in. open-end wrench).

• ZH
• FR
• RU
• JA
• EN

While holding the fitting body steady, tighten the plug onequarter turn from the finger-tight position.

• RU
• JA
• EN

Swagelok® series 8HPH (high performance) weld heads deliver consistent, precise welds for outside diameters from 1/8 to 1/2 in. and 3 to 12 mm.

• JA
• EN

Remove snap ring from bottom of plug using snap ring pliers. Remove plug/handle subassembly by lifting straight up on handle.